Blog Information

• Posted By : wistar motor
• Posted On : Apr 18, 2022
• Views : 88
• Category : Travel
• Description : There is a set of gears and micro switch devices at the end of the motor.

Overview

• There is a set of gears and micro switch devices at the end of the motor. The wiring of the motor requires forward and reverse rotation, so as to realize the self-positioning of the curtain opening and closing stroke. Motorized Shades Blinds Suppliers introduced the itinerary as follows:

  1. Before adjusting the stroke, first separate the motor and the transmission box of the track, so that the pulley of the track is at the end position of fully open and fully closed. Remove the motor tail cover, you can see the left and right knobs.

  2. There is a positioning locking piece between knobs ① and ②. Move the positioning locking piece to the knob ②, and push the button ① in. You can see the gear is separated from the teeth and the state from the transparent casing. At this time, turn the knob ① with your fingers. Both forward and reverse rotations are possible, so that the grooves on the three groove rings (the middle one is the color ring) are in a line.Turn off the action (the corresponding micro switch enters the short-circuit state), gently pull out the knob ① (do not turn it), so that the gears enter the meshing state, and the adjustment of the knob ① is completed.

  3. Then adjust the knob ②, make the positioning lock plate move towards the knob ①, and push the knob ② to make the gears disengage from the meshing state. Repeat all the adjustment actions of the knob ① to make the positioning micro switch enter the short-circuit state.

  4. Install the motor on the transmission box of the track, and push the pin plate into the transmission box to fix it. Turn on the power supply, power on the motor through the switch of the controller, turn the locking piece to the knob ①; push the knob ② in and turn it slightly (both forward and reverse); When the required position is specified, immediately cut off the power to the motor, and gently pull out the Press button ② to make the gears enter the meshing position.

  5. Change the direction of the motor through the switch of the controller, and push the locking piece to the knob ②, push the knob ① in and turn it slightly (both positive and negative directions), then immediately cut off the power to the motor, and gently pull out the knob ①, Bring the gears into meshing position.

  6. Both knobs ① and ② are in the gearing transmission state, and the adjustment work is over.

  7. Tighten the back cover with screws, and the positioning lock piece is fixed.

  Through the above introduction, Dc Solar Motor For Roller Shutter Exporter hopes that you can simply refer to the content of this article in future use.