Judge sends Philly's first talc powder trial
The first talcum powder/cancer trial in Philadelphia will take place in state court, after a federal judge recently ruled that Johnson... moreJudge sends Philly's first talc powder trial
The first talcum powder/cancer trial in Philadelphia will take place in state court, after a federal judge recently ruled that Johnson & Johnson was wrong in its attempts to remove the case from the federal venue on the very day jury selection was to take place.Get more news about Pa Powder,you can vist our website!
U.S. District Court for the Eastern District of Pennsylvania Judge Michael M. Baylson turned away arguments from defense counsel, which postulated that attorneys for plaintiffs Ellen Kleiner and Yuri Kleiner acted in bad faith by initially suing Pennsylvania-based Rite Aid in an attempt to keep the case in state court, only to dismiss those claims the day before trial.
The Kleiners, of Richboro, first filed suit in the Philadelphia County Court of Common Pleas on Jan. 18, 2017 versus Rite Aid Corporation and Rite Aid of Pennsylvania, Inc. of Camp Hill, Johnson & Johnson and Johnson & Johnson Consumer, Inc. of New Brunswick, N.J., Imerys Talc... less
Tripropylene glycol monomethyl ether (TPM) dissolves liquid resin, making it effective for washing parts printed on Formlabs SLA printers. Depending on your use case and work... moreTripropylene glycol monomethyl ether (TPM) dissolves liquid resin, making it effective for washing parts printed on Formlabs SLA printers. Depending on your use case and work environment, TPM may be a viable alternative to isopropyl alcohol (IPA) for washing parts using the Form Wash, Form Wash L, or the Finish Kit.Get more news about Tpm 3d,you can vist our website!The surface of the part may have a waxy feel until it is fully dry. Some resins, noted below, may have additional surface waxiness for up to a week if they are not post-cured. When post-curing, follow the recommendations in the support article Form Cure time and temperature settings for each resin. Printed parts washed in TPM will feel indistinguishable from parts washed in IPA once they are post-cured.TPM can dissolve roughly three times the amount of resin as IPA before losing efficacy. If a thin film of resin remains on printed parts after washing with TPM, the solvent is overly contaminated with resin and should be replaced. Replace... less