According to 100w Street Light Housing  Supplier, the brightness of LED is adjusted by adjusting the size of the current passing through it. Energy-saving lamps generally cannot adjust the brightness because the voltage is low when the lamp is turned on, and it cannot penetrate the tube to light up. Incandescent lamps can adjust the brightness by adjusting the lamp voltage.

1. If the LED light is too bright, you can find a professional to install the light adjuster. There are various types of LEDs, and there are types that can be dimmed and bright. This kind of lamp can be the first choice, but if you have installed a high-brightness lamp in your home, you can also find a professional to install a brightness adjuster, so that you can control the brightness Now, you can turn down the brightness before going to bed, and when you are not drowsy, you can turn it up to read books and magazines.

2. The input voltage of the regulator is AC90V-240V. Connect the load line first, then the power line, and make sure that there is no short circuit between the connecting lines before powering on. Panel knob: Turn the knob clockwise to increase the brightness, and turn it counterclockwise to decrease the brightness. Remote control operation: Point the remote control at the infrared receiver to ensure that there are no interfering obstacles between the remote control and the receiver. When the dimmer receives an effective signal from the infrared remote control, its upper indicator flashes. If you are not sure, it is safer to find a professional to install it.

Through the above introduction, Sensor Led Street Light Housing  Manufacturers hopes that you can simply refer to the content of this article in future use.