How to choose a kitchen sink that belongs to you. Today, Stainless Steel Handmade Sink Manufacturers will share the details of the common sink selection.

The standard sink is generally about 20cm deep, so that the dishwashing is more convenient and can prevent splashing. At the same time, the vertical angle of the basin wall of 90 degrees can increase the use area of ​​the sink. If the water hole is in the center of the water tank, the space for the cabinet will be reduced. The water hole below is behind, and the water pipe is installed close to the wall, which not only makes the water quick, but also effectively utilizes the space.

Thickness: The thickness of the steel plate of the stainless steel sink is preferably between 0.8 and 1.2 mm. Within this thickness, 304 stainless steel is selected and the sink has toughness. The easiest way to identify it is to press the surface of the sink a little bit. If it is pressed, the material is very thin.

Depth: The height of the sink suitable for domestic use is more than 180mm, which has the advantages of large capacity and splash resistance.

Surface flatness: This is the most intuitive standard for checking the quality and grade of the sink. The line of sight is consistent with the plane of the sink. The edge of the sink should not protrude and not warp. The error is less than 0.1mm. If the flatness is not good, in addition to affecting the appearance, it is also easy to cause water seepage and fouling.

Accessories: The quality of the sewer and the down pipe directly affects the use of the sink. The better material of the down pipe should be PP material or UPVC. It has high sealing degree, elasticity, heat resistance, crack resistance, long service life, reasonable shape design and deodorization. , anti-back taste design, easy to install, no blockage, water seepage and other phenomena.

information about Stainless Steel Handmade Sink Manufacturers : https://www.afastainlesskb.com/product/sink/handmade-sink/