-
Encontrar enMiembros
Encontrar enVideos
Encontrar enCanales
This website uses cookies to ensure you get the best experience on our website.
To learn more about our privacy policy haga clic aquíPreferencia de privacidad
Información
xiu umin
(Propietario)
(Propietario)
- Última actualización 22 de marzo de 2019
- 0 comentarios, 2 vistas, 1 me gusta , 0 seguidores, miembro de 1
You May Also Like
-
21 de enero de 2022 - publicado por Brendon Davenport0 comentarios, 0 opiniones, 6 vistas, 1 me gusta -
22 de marzo de 2022 - publicado por Dokotsa Designs0 comentarios, 0 opiniones, 4 vistas, 1 me gusta -
26 de abril de 2023 - publicado por Killex Pest Control0 comentarios, 0 opiniones, 9 vistas, 1 me gusta -
21 de agosto de 2023 - publicado por Floor Polishing Melbourne0 comentarios, 0 opiniones, 2 vistas, 1 me gusta -
17 de agosto de 2023 - publicado por IRG Cayman0 comentarios, 0 opiniones, 4 vistas, 1 me gusta
Actualizaciones
Información
¿Quieres reportar esto? ¿Por qué no te gustó?
¿Quieres reportar esto? ¿Por qué no te gustó?
¿Quieres reportar esto? ¿Por qué no te gustó?
Información básica
- Publicado por: xiu umin
- Al corriente: Mar 23, 2019
- Última actualización: Mar 23, 2019
- Members: 1
- Puntos de vista: 2
- Gustos: 1
, showing an area that is usually close to the door, which has an uneven lining appearance. It may be reminiscent of a groove on a phonograph record, or it may...MásThis type of failure occurs in many Household Product Mould(FURNITUREMOULD) https://www.furnituremould.com/product/daily-necessities-mould/
, showing an area that is usually close to the door, which has an uneven lining appearance. It may be reminiscent of a groove on a phonograph record, or it may appear to appear as an irregular line pattern, roughly a semicircle around the door.
The reason for unfolding the mark is that the pressurization of the last part of the household product mould is slow. As the back pressure in the household product mould increases, the rate at which the material flows through the gate decreases, and the molten plastic does not have a sufficiently low viscosity to provide good consistency of the mold surface.
In order to overcome this drawback, it is important to quickly fill the mold of the household product at one time. If the machine runs out of power before the filling is complete, the last material can only enter the household product mould at a very slow rate. The pressure in the hydraulic system will gradually increase and will be transferred to the material entering the mold of the household product for further pressurization.
Click Daily Necessities Mould https://www.furnituremould.com/product/daily-necessities-mould/
to learn about more information. Menos
0 comentarios
-
A xiu umin le gusta esto
