معلومات
xiu umin
(صاحب)
(صاحب)
- آخر تحديث ٤ يونيو، ٢٠١٩
- تعليق ٠ , وجهات النظر ١, يحب ١, متابع ٠ , أعضاء ١
You May Also Like
-
٢١ أكتوبر، ٢٠٢١ - منشور من طرف Riaan Burmanتعليق ٠ , استعراض ٠ , ٤ views, يحب ١ -
-
١٧ فبراير - منشور من طرف Joshua Stevensonتعليق ٠ , استعراض ٠ , ٤ views, يحب ١
-
١٤ مايو، ٢٠١٩ - منشور من طرف xiu uminتعليق ٠ , استعراض ٠ , وجهات النظر ١, يحب ١
-
٢٤ سبتمبر - منشور من طرف Academy Heating & Air, Inc.تعليق ٠ , استعراض ٠ , ٣ views, يحب ١
التحديثات
معلومات
هل تريد الإبلاغ عن هذا؟ لماذا لم يعجبك؟
هل تريد الإبلاغ عن هذا؟ لماذا لم يعجبك؟
هل تريد الإبلاغ عن هذا؟ لماذا لم يعجبك؟
معلومات اساسية
- منشور من طرف: xiu umin
- تاريخ النشر: Jun 05, 2019
- آخر تحديث: Jun 05, 2019
- Members: 1
- الآراء: 1
- الإعجابات: 1
. Usually, the simplest system is a system that drills longitudinally through a template. However, this is not...أكثر منIt is the responsibility of the mould designer to provide adequate circulation within the Table Mould(FURNITUREMOULD) https://www.furnituremould.com/product/chair-table-stool-mould/
. Usually, the simplest system is a system that drills longitudinally through a template. However, this is not necessarily the most efficient method for a particular mould.
However, when drilling is used for the circulation of the coolant, these should not be too close to the indentation (eg, less than 16 mm) as this may result in significant temperature changes on the indentation, resulting in moulding problems.
The layout of the circuit is often complicated because the runners cannot be placed too close to any other hole in the same template. It can be recalled that the template has a large number of holes or grooves to accommodate the ram, the guide post, the guide sleeve, the sprue bushing, the insert, and the like. The degree of safety in positioning in the direction of flow adjacent to another orifice depends to a large extent on the depth of drilling of the desired flow pattern. When drilling deep runners, the drill tends to deviate from its prescribed route. The rule that is often applied is that for holes up to 150 mm deep, the flow should not be less than 3 mm of any hole. For deeper flow patterns, this margin is increased to 5mm.
Click Chair Mould https://www.furnituremould.com/product/chair-table-stool-mould/
to learn about more information. أقل
تعليق ٠
-
xiu umin مثل هذا
