Page Information

• Posted By: minseok kim
• Posted On: Aug 15, 2019
• Views: 1
• Likes: 1
• Category: Places
• Description: The conveyor belt using a Roller chain(GETECHAIN) https://www.getechain.com/product/driving-chain/heavy-roller-chain/ is not prone to snaking and deviation, and because the belt is thick and can withstand cutting, bumping, oil resistance, water-resistance, and other characteristics, the industry will not encounter troubles in maintenance when using it, especially when replacing the plastic steel belt conveyor on the conveyor belt, which will reduce an expense. We should understand the operating performance of this object and the relevant precautions, then separate from the relevant key points and do a good job of maintenance. Only in this way can we extend the sensitivity of the sprocket. Other products with guaranteed quality will also have various problems with the passage of time. Therefore, users need to control the operating strength of the sprocket, stick to its tightness and reach the specified standard. If it is too tight, it will also greatly increase its consumption rate. Therefore, this will lead to severe wear of bearings. If other sprockets are too loose, there will be obvious chain release. Therefore, during operation, we will set the spacing within the regular range. At the same time, the staff also need to adjust the center distance of the sprockets below 0.5 meter to avoid obvious errors. Otherwise, friction effect will occur between the two wheels. Therefore, the operator should check and check the pauses of the sprockets. Hyperbolic gear transmission is widely used in car rear axle final drive because of its good meshing smoothness and large reduction ratio. However, due to the high transmission pressure and high relative sliding speed in the meshing transmission process of hyperbolic gears, high instantaneous temperature occurs. Under such extreme pressure conditions, in order to avoid abrasion, scratch, and adhesion, the friction on the metal touch surface must be reduced, so some organic compounds are added into hyperbolic gear oil as extreme pressure additives. For general gear transmission, the unit pressure of the tooth surface is low and the working temperature is not high, so the oil film is not easy to crack and the smooth condition is good, so extreme pressure additive is not necessary. If hyperbola gear oil is used, some additives will produce effects, thus causing unnecessary corrosion and wear of gears. Therefore, it is not correct to simply think that hyperbola gear oil has good performance and can replace common gear oil. Instead, gear oil with appropriate performance should be selected according to the characteristics of gear transmission. Click heavy roller chain https://www.getechain.com/product/driving-chain/heavy-roller-chain/ to learn about more information.