Loading ...-
Zheng ri posted a new blog entry:
The design of the cooling system is very important in Syringe Mold. This is because the moulding of the plastic product is only cooled to a certain degree of rigidity, and then the plastic product is released from the Table Mould to avoid deformation due ...- #The_design_of_the_cooling_system_is_very_important_in_Syringe_Mold
- #and_then_the_plastic_product_is_released_from_the_Table_Mould_to_avoid_deformation_due_to_external_force
- #the_design_of_a_good_cooling_system_can_greatly_shorten_the_moulding_cycle_time
- #increase_the_injection_moulding_rate_and_reduce_the_cost
- #and_even_more_cooling_time_can_exacerbate_the_warpage_of_plastic_products
- #the_heat_transferred_from_the_melt_to_the_table_mould_is_usually_divided_into_two_parts
- #one_part_is_5
- #transferred_to_the_atmosphere_by_radiation_and_convection
- #and_the_remaining_95
- #the_heat_in_the_plastic_cavity_is_transferred_to_the_cooling_water_pipe_by_the_convective_heat_carried_away_by_the_coolant
- #and_the_mould_is_dispersed_in_the_air
- #filling_time
- #holding_time
- #cooling_time_and_injection_time
- #which_is_about_70
- #the_cooling_time_will_directly_affect_the_moulding_cycle_time_and_output_rate_of_plastic_products
- #contact_us
There are no more results to show.
