In the tension adjustment device of Pull Stenter, the wheel brush is connected to the bearing, the cover is arranged on the wheel brush and after the two are connected, the slurry cavity is closed and rotated, and the circuit board and the cover are connected to the application system. And the brush wheel and the edge of the adjacent position, the wheel brush and the fabric equipment are connected, and then apply the brush to the edge of the cloth, during the dyeing process and the adjustment of the fabric, the size of the fabric edge can solve the inner curve and shrink the fabric. problem.

Installation and use requirements of the bushing mold of the stenter setting machine

      In the adjustment center of the die center of the stenter setting machine, the two ends of the sleeve and the toothed ring ring are formed and the lower die is fixed to the punch and the operating table screw. The lower die has a high circle and the groove teeth are fixed on The punch of the punching machine and the punch tooth top ring are formed by circular tooth top ring rows, and are formed in the fixed plate high ring seal, the fixed plate tooth top ring and the keyway tooth top ring are formed, and the square perforated tooth top The coupling of the ring, so the top ring is formed on the top of the cylindrical tooth, and the outer diameter of the cylindrical gear is larger than the inner diameter of the sleeve, and the square plate is printed with a high circular bottom.

      In the design of the central configuration frame, its operation is stable, high performance, and precision. The central configuration of the machine tool is a combination of multiple chain link units through the combination of links, and the ring chain includes upper and lower chains, and the port pin chain is The two chain ends of the upper and lower chains and the deep groove, and the through hole part is opened correspondingly, the cylindrical panel is embedded in the through hole, the bearing deep groove ball sleeve is wrapped around the pin axis, and the upper end of the pin shaft is provided with After inserting the bolt into the through hole, screw the bolt into the threaded hole, and insert the edge of the pressure plate into the slot.

Nowadays Flat Screen Printing Machine's cutting device, used for cutting machine pick-up roller, is to set the air supply pipe above and below the frame material, its blow molding pipe is arranged at the correct feeding end, and the left end of the cutter and the pick-up roller There is a suction pipe. The suction pipe includes a square oblique pipe and a vertical square pipe. The vertical square pipe is connected to the suction fan. The structure is simple, so the application effect is good.