You Can Debug Rubber Extruder In These Steps
  • Etiquetas - #rubber extruder
    • Última actualización 29 de septiembre de 2020
    • 0 comentarios, 163 vistas, 0 likes

More from na bai

  • Have You Ever Known More About Rubber Extruder?
    0 comentarios, 0 likes
  • You Need to Know Features of Rubber Curing Oven
    0 comentarios, 0 likes
  • Care About Foreign Development Situation of Rubber Extruder
    0 comentarios, 0 likes

More in Politics

  • Norton antivirus account login
    28 comentarios, 131.924 vistas
  • Liquidity Locking Made Easy
    9 comentarios, 81.677 vistas
  • Ang jili178 login ay nagdudulot sa iyo ng mga laro ng slot at karanasan sa laro ng soccer
    2 comentarios, 45.728 vistas

Related Blogs

  • \u0e2a\u0e31\u0e15\u0e27\u0e4c\u0e1b\u0e48\u0e32
    0 comentarios, 0 likes
  •  Yuvraj Singh\u2019s Insight: Decoding India\u2019s Prospects for the ICC Men\u2019s T20 World Cup 2024
    0 comentarios, 0 likes
  • Buying Annapolis Valley Properties
    0 comentarios, 0 likes

Archivo

compartir social

You Can Debug Rubber Extruder In These Steps

Publicado por na bai     29 de septiembre de 2020    

Cuerpo

The steps of rubber extruder debugging are as follows:

   1. The temperature control check should be done before starting to make sure that the temperature control is normal, the instrument is normal, and the cooling water circuit is unblocked.

  2. The screw, barrel and die of the rubber extruder need to be heated. Generally, the temperature reaches the appropriate temperature and keeps it warm for a while before starting up.

   3. Make sure that the screw connections of each part of the head should be tightened while hot.

   4. When starting to extrude, the rotation speed of the screw should not be too fast to prevent overload, but it needs to be accelerated slowly.

   5. When starting up, add a small amount of materials, and gradually increase the amount of materials after the various meter values are stable.

   6. If the parison is not formed at the entrance end of the shaping mold, you can use tools to poke some small holes at the entrance end.

  7. If you encounter mold blockage but not blocked, you can move the setting table back or increase the traction speed.

   8. When the rubber extruder is shut down, it is necessary to drain the remaining material inside the barrels, then shut down, and pull the machine to preheat, remove the die and clean it.

Comentarios

0 comentarios