Does the appearance of the Flower Pot directly affect the company's sales business? Is this true?

　　The appearance of Flower Pot Mould directly affects the company's sales business, affects the company's image, gives customers the illusion of product quality problems, affects cooperation, and causes unnecessary economic losses.

　　To understand the nature of raw materials, please adjust the process formula reasonably. The technical parameters of blow-molded tray products strictly comply with national standards, and the product appearance design and product size can also be customized according to needs. Flower Pot products are widely used in chemical, dye, pharmaceutical, pesticide, metallurgy, rare earth, machinery, electronics, environmental protection, textile, food, and other industries. If the fluidity of the raw material after heating is poor, it will cause the brightness of the barrel wall.

　　Due to external influences, the moisture in the raw materials is very large. The large amount of water vapor generated during the production process will cause the cylinder wall to be found dark rather than bright during the production process.

　　In the production process of Flower Pot, recyclable materials are added, and its proportion is large so that the appearance of the barrel is bright. This problem can be solved by reducing the proportion of recycled materials and adding low-pressure resin appropriately (Emerson).

　　Leaks in the Flower Pot Mould cooling system and long-term operation of the mold can cause corrosion and damage the sealing system. Water leakage occurs in some parts of the mold, causing the barrel wall to become blunt. The sealing strip should be replaced to ensure that the leakage problem is solved. The automotive mold exhaust system is not good. During the production process, too much gas will remain on the mold, resulting in poor gloss. Therefore, the mold exhaust system must be inspected and repaired in time.

　　Injection molding process problems: insufficient packaging pressure, short packaging time, resulting in insufficient barrel density (unit: g/cm3 or kg/m3), poor gloss, packaging pressure should be increased to delay the packaging time.