Before plugging the China glue gun into the power supply, please check whether the power cord is intact, whether the bracket is ready, and whether the used glue gun has poured glue. Before using the glue gun, please preheat it for 3-5 minutes. When the glue gun is not in use, please stand upright on the table. In addition, please keep the surface of the hot melt adhesive strip clean to prevent impurities from blocking the nozzle.

If you find that the glue gun does not produce glue during use, first check whether the glue gun is hot. If the glue gun does not heat normally, the cause may be that the power of the glue gun is not plugged in or the glue gun is burnt due to a short circuit.

If the glue gun does not produce glue under normal heating conditions, it may be because the glue gun pours the glue and makes the glue strip thicker. At this time, just gently rotate the glue strip once and carefully pull out a small part backwards. Strip off the thickened part of the rubber strip, and then continue to use. However, if it is due to impurities in the mouth of the gun blocking the glue outlet, please seek professional treatment.

When using the glue gun, try to avoid a humid environment. Humidity will affect the insulation performance and may cause electric shock. In addition, do not pull out the adhesive strip from the glue inlet. Hot melt adhesive will cause severe burns or damage to the glue gun. The parts of the China spray gun electric heating cannot be disassembled and installed at will, otherwise it will cause its failure.