More from krista medicalmould
More in Politics
Related Blogs
Archives
Social Share
Components of the syringe mold
Posted By krista medicalmould
Body
- Forming part. That is, after the Syringe Mould is assembled and closed, it directly forms the component parts of the cavity of the plastic product, such as a convex mold, a concave mold, a core, a rod or an insert, etc.
- Mold clamping guide part. It is a component set to make the movable and fixed syringe molds align with the center axis correctly when the mold is closed. There are guide posts, guide hole sleeves or inclined taper parts.
- Product launch part. It is the parts used to push the molded injection product out of the mold cavity of the molded syringe, including ejector rod, fixed plate, push plate and cushion block.
- The core drawing part. When demolding plastic products with pits or side holes in injection molding, first pull out the core mechanism parts for pits and side holes, such as the frequently used inclined guide posts, inclined sliders, and bent pins.
- Heating and cooling part of the syringe mold body. It refers to a control system that adapts to the temperature of the injection molding process of plastic products, such as resistance heating plates, rods and their electronic control components; the cooling part uses circulating cooling water pipes, etc.
- The supporting part of the syringe mold body. It refers to the auxiliary parts to ensure the correct operation of the syringe mold body, such as movable and fixed mold pads, positioning rings, lifting rings and various fastening screws.
- Pouring melt channel. It refers to the flow channel that can lead the molten material injected through the nozzle to the cavity of the molding syringe mold. It can usually be divided into the main flow channel, the branch flow channel, the bushing mouth (gate) and the cold chute.
- Vent holes. It refers to the part that can discharge the air in the syringe mold cavity. Generally, small products do not need to be specially equipped with vent holes, and the air in the cavity can be discharged from the gap between the matching parts; for large injection products, Medical Mould must be provided with vent holes.
Comments