How to make and install wire magazine holder:

　　1.) Drill holes in the grid of paint cans.

　　You can find paint grids in various sizes, from 5 gallons to the smallest few smaller sizes. For the wall-mounted magazine rack, we chose a 1-gallon grid. After purchasing the paint can grid, you need to drill two holes to fix the grid to the wall with screws.

　　2.) The sandblasted grid can break up any sharp/rough areas.

　　These paint grids can be very rough and have sharp edges. Use a sandpaper block to sand off the sharp edges of the entire grid. Of course, we don’t want to cut ourselves on a stupid magazine rack, so safety is better than regret. I used 150 grit sandpaper on the sandpaper block and sanded the entire grid with good sandpaper.

　　3.) Install drywall anchors.

　　After writing with a pencil on the wall where the wire magazine holder will be placed, continue the operation and put some drywall anchors. You will first drill a few holes, and then use a hammer to insert anchors into the holes.

　　4.) Screw the paint grid to the wall.

　　Go ahead and grab the two screws, then use a drill bit screwdriver to fix the grid to the wall. You are done! All you need is your magazine. Or in our case, there are some books about potty training and underwear and any books related to potty. We are hanging out here.

　　wood hanger hooks are also our product, welcome to consult and purchase.